ADTRAN 5000 Series - Manual (Page 917)

Command Reference Guide PPP Interface Configuration Command Set
61200990L1-35E Copyright © 2005 ADTRAN 917
fair-queue <threshold>
Use the fair-queue command to enable weighted fair queuing (WFQ) on an interface. Use the no form of
this command to disable WFQ and enable FIFO queueing for an interface. WFQ is enabled by default for
WAN interfaces.
Syntax Description
<threshold> Optional. Specifies the maximum number of packets that can be present in each
conversation sub-queue. Packets received for a conversation after this limit is
reached are discarded. Range: 16 to 512 packets.
Default Values
By default, fair-queue is enabled with a threshold of 64 packets.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example enables WFQ on the interface with a threshold set at 100 packets:
(config)#interface ppp 1
(config-ppp 1)#fair-queue 100