Join-prune-msg-interval <seconds – ADTRAN 5000 Series User Manual
Page 1130
Advertising

Command Reference Guide
Router (PIM Sparse) Configuration Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
1130
join-prune-msg-interval <seconds>
Use the join-prune-msg-interval command to set a timing rate for PIM sparse join/prune messages.
Syntax Description
<seconds>
Specifies the PIM sparse join/prune message interval.
Valid range: 10 to 65534 seconds.
Default Values
By default, the message interval is set to 60 seconds.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and the Total Access 900 Series units.
Command History
Release 11.1
Command was introduced.
Usage Examples
The following example sets the interval for 50 seconds:
(config)#router pim-sparse
(config-pim-sparse)#join-prune-msg-interval 50
Advertising