Dhcp pool command set, Dhcp pool command set 5, Dhcp p – ADTRAN 5000 Series User Manual

Page 1145: Ommand

Advertising
background image

Command Reference Guide

DHCP Pool Command Set

61200990L1-35E

Copyright © 2005 ADTRAN

1145

DHCP P

OOL

C

OMMAND

S

ET

To activate the DHCP Pool mode, enter the ip dhcp-server pool command at the Global Configuration
mode prompt. For example:

>enable
#configure terminal
(config)#ip dhcp-server pool MyPool
(config-dhcp)#

The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:

cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>

on page 28

do

on page 32

end

on page 33

exit

on page 34

shutdown

on page 35

All other commands for this command set are described in this section in alphabetical order.

client-identifier <identifier>

on page 1146

client-name <name>

on page 1148

default-router <address> <secondary>

on page 1149

dns-server <address> <secondary>

on page 1150

domain-name <domain>

on page 1151

hardware-address <hardware-address> <type>

on page 1152

host <address> [<subnet mask> or <prefix length>]

on page 1154

lease <days> <hours> <minutes>

on page 1155

netbios-name-server <address> <secondary>

on page 1156

netbios-node-type <type>

on page 1157

network <address> [<subnet mask> or <prefix length>]

on page 1158

ntp-server <ip address>

on page 1159

option <option value> [ascii | hex | ip] <value>

on page 1160

tftp-server <server>

on page 1161

timezone-offset <offset>

on page 1162

Advertising