ADTRAN 5000 Series - Manual (Page 474)

Command Reference Guide Line (Console) Interface Config Command Set
61200990L1-35E Copyright © 2005 ADTRAN 474
flowcontrol [none | software in]
Use the flowcontrol command to set flow control for the line console.
Syntax Description
none Specifies no flow control.
software in Configures AOS to derive flow control from the attached device.
Default Values
By default, flow control is set to none.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1 Command was introduced.
Usage Examples
The following example configures no flow control for the line console:
(config)#line console 0
(config-con 0)#flowcontrol none