ADTRAN 5000 Series - Manual (Page 299)

Command Reference Guide Global Configuration Mode Command Set
61200990L1-35E Copyright © 2005 ADTRAN 299
arp <ip address> <mac address> arpa
Use this command to enter static entries into the address resolution protocol (ARP) table.
Syntax Description
arpa Sets the standard address resolution protocol for this interface.
<ip address> Specifies the IP address.
<mac address> Specifies the MAC address.
Default Values
The default for this command is arpa.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 5.1 Command was introduced.
Release 6.1 Command was extended to include NetVanta 2000 Series units.
Usage Examples
The following example enables standard ARP for the VLAN interface:
(config)#interface vlan 1
(config-interface-vlan 1)#arp 196.173.22.253 00:A0:C8:00:00:01 arpa