Router (ospf) configuration command set, Router (ospf) configuration command set 4, Ction router (ospf) configuration command set – ADTRAN 5000 Series User Manual
Page 1114: Ospf) c

Command Reference Guide
Router (OSPF) Configuration Command Set
61200990L1-35E
Copyright © 2005 ADTRAN
1114
R
OUTER
(OSPF) C
ONFIGURATION
C
OMMAND
S
ET
To activate the Router (OSPF) Configuration mode, enter the router ospf command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router ospf
(config-ospf)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
All other commands for this command set are described in this section in alphabetical order.
area <area id> default-cost <value>
area <area id> range <ip address> <network mask> [advertise | not-advertise]
area <area id> stub [no-summary]
auto-cost reference-bandwidth <rate>
default-information-originate [always | metric <value> | metric-type <type>]
network <ip address> <wildcard> area <area id>
redistribute connected [metric <value> | metric-type <type> | subnets]
redistribute rip [metric <value> | metric-type <type> | subnets]
redistribute static [metric <value> | metric-type <type> | subnets]
summary-address <address> <mask | prefix mask> not-advertise