Rockwell Automation GV3000/SE AC Gen. Purpose & Vector Bookshelf Drive Start-Up and Reference Manual - Manual (Page 16)

1-2 GV3000/SE AC Bookshelf Drive Software Reference, Version 6.06
1.1 Preparing for Start Up (Volts/Hertz)
Read through the following sections to prepare for the start-up procedure.
What You Need to Know:
• You must be qualified to perform the procedure and be familiar with V/Hz regulation.
• You should be familiar with the keypad/display. If you are not familiar with the
keypad/display, refer to chapter 3, which describes it.
What You Need to Do:
• Complete all hardware installation as described in the hardware reference manual.
This includes connecting input power, input transformers (if required), disconnects,
fuses, and the terminal strip on the drive.
• Record the following motor data from each motor nameplate for use during the
procedure. Space is provided for recording information from three motors:
• Connect the drive to the motor.
• Check that you have not been prevented from programming the drive. If the PASS
LED on the keypad is on, programming has been prevented in parameter P.051,
Programming Disable. Refer to section 4.4 in this manual for the procedure to
enable programming.
If You Have a Problem:
To Exit:
During most of the start-up procedure, you will be in program mode, which is used to
program parameters. If you want to stop programming parameters, you can exit
program mode. You can do this by pressing the PROG key until the PROG LED turns
off. This will place the keypad/display in monitor mode, the default. You can read more
about these modes in chapter 3.
To Restore a Default Parameter Value after Writing over It:
If you enter the wrong value while programming parameters, you can restore the
default if you have not yet pressed the ENTER key. To do so:
1. Press the PROG key.
2. Press the ENTER key. The default value of the parameter will be displayed again.
You can select it with ENTER or enter a new one and press ENTER.
Motor rated amps:
Motor rated volts:
Motor base frequency:
Motor rated amps:
Motor rated volts:
Motor base frequency:
Motor rated amps:
Motor rated volts:
Motor base frequency: