Rockwell Automation GV3000/SE AC Gen. Purpose & Vector Bookshelf Drive Start-Up and Reference Manual - Manual (Page 83)

Using the Keypad/Display to Program, Monitor, and Control the Drive 3-7
Important: The STOP/RESET key can be disabled by P.055. See the P.055
parameter description for more information.
Use the ▲ and ▼ keys to:
• Step through the drive parameter menus and error log when the
keypad/display is in program mode
• Increase (or decrease) a numeric value (such as the reference or
a parameter value)
Hold down these keys to increase the scroll speed.
Use the ENTER key to:
• Display a parameter (or a selection) value in program mode
• Save a value
• Move through each monitor display item when in monitor mode
Use the FWD/REV key to select the direction of motor rotation when
the control source is local (REM LED is off). This key is ignored if the
control source is not local (REM LED is on). See the FWD and REV
LED descriptions for more information.
Refer also to the P.027 (Forward/Reverse Configuration) parameter
description.
Use the PROG key to move between program and monitor modes.
The PROG LED turns on when the keypad/display is in program
mode and turns off when the keypad/display is in monitor mode.
Use the RUN/JOG key to toggle between run and jog when in local
control (REM LED is off). When run is selected, pressing the START
key results in continuous drive operation. When jog is selected,
pressing the START key results in drive operation only until the
START key is released.
This key is ignored if the control source is not local (REM LED is on).
See the RUN and JOG LED descriptions for more information.
Use the START key to apply power to the motor in local control
(REM LED is off). See the RUN LED description for more
information.
If the drive is running (RUN LED is on), the STOP/RESET key stops
the drive. If the drive is not running (RUN LED is off), pressing this
key resets drive faults. Refer also to the STOP/RESET Key Disable
Parameter (P.055).
% #
):'
5(9
352*
581
-2*
67$57
6723
5(6(7