Rockwell Automation GV3000/SE AC Gen. Purpose & Vector Bookshelf Drive Start-Up and Reference Manual - Manual (Page 77)

Using the Keypad/Display to Program, Monitor, and Control the Drive 3-1
C
HAPTER
3
Using the Keypad/Display to Program,
Monitor, and Control the Drive
The front-panel keypad/display is used to program, monitor, and control the drive. It
operates in two modes, monitor mode and program mode. The functions available at
the keypad depend on what mode the keypad/display is in and what is selected as the
drive control source.
In monitor mode (the default mode), you can monitor specific drive outputs as well as
enter the speed or frequency reference for the drive.
In program mode, you can view and adjust drive parameter values, and examine the
error log.
In addition to the functions listed above, if the control source is local (the REM LED is
off), the keypad is also used to select run or jog, select motor direction, and start the
drive.
Regardless of the control source selection, the keypad/display can be used to stop the
drive, reset drive faults, and switch between a manual speed reference or the selected
control source auto reference.
Important: The STOP/RESET key can be disabled by parameter P.055. Refer to the
P.055 parameter description for more information.
The following sections describe monitor mode and program mode in more detail. The
keypad, display, and LEDs are described later in this chapter.
Figure 3.1 – Keypad/Display
S
):'
5(9
$872
0$1
(17(5
581
-2*
352*
67$57
6723
5(6(7
530
9
$
+]
N:
754
3$66
581
5(0
-2*
$872
):'
5(9
352*
Display
Monitor Mode LEDs
Password LED
Drive Status LEDs
Keypad
STOP/RESET Key START Key