Rockwell Automation GV3000/SE AC Gen. Purpose & Vector Bookshelf Drive Start-Up and Reference Manual - Manual (Page 28)

1-14 GV3000/SE AC Bookshelf Drive Software Reference, Version 6.06
Step 5.9 Press the ENTER key.
After pressing ENTER, the same
parameter is displayed. You can now
move to the next parameter.
Step 5.10 Press the ▲ key to display H.002, Motor Nameplate Amps.
This parameter specifies the Motor
Nameplate Amps and is taken directly
from the motor nameplate.
Step 5.11 Press the ENTER key.
The default setting depends on the drive
rating. The display shown here is only
an example.
KL
530
9
$
+]
N:
754
3$66
581
-2*
$872
):'
5(9
352*
5(0
!
ATTENTION: This parameter setting must not exceed the rated amps
found on the motor nameplate. Excess heating of the motor could result
if this is not the case. Failure to observe this precaution could result in
damage to, or destruction of, the equipment.
K
530
9
$
+]
N:
754
3$66
581
-2*
$872
):'
5(9
352*
5(0
L
530
9
$
+]
N:
754
3$66
581
-2*
$872
):'
5(9
352*
5(0