Rockwell Automation GV3000/SE AC Gen. Purpose & Vector Bookshelf Drive Start-Up and Reference Manual - Manual (Page 69)

Starting Up the Drive for Vector Regulation 2-31
Important: The stop input on the terminal strip is not active when the Control Source
parameter (P.000) is set to LOCL, as it is during this start-up procedure.
Use the STOP/RESET key if you need to stop the drive.
Step 10. Check Motor Rotation Direction
This step involves verifying the speed reference is set to minimum speed, starting the
drive, and checking that the motor rotates in the correct direction. It is performed with
the motor disconnected from the load.
Step 9.3. Press the ▲ key until U.009 is displayed.
Step 9.4 Press the ENTER key to view the test result.
Step 9.5 Refer to the U.009 parameter description in chapter 4 for the
corresponding cause and corrective action.
Step. 9.6 Once the cause of the fault has been corrected, repeat the self-tuning
procedure (step 8).
!
ATTENTION: The subsequent steps require rotating parts and/or
electrical circuits to be exposed. Stay clear if the drive must be running,
or disconnect and lock out or tag power source if contact must be made.
Failure to observe this precaution could result in severe bodily injury or
loss of life.
Step 10.1 Press the PROG key until the PROG LED turns off.
The keypad/display will enter monitor mode.
X
530
9
$
+]
N:
754
3$66
581
-2*
$872
):'
5(9
352*
5(0

530
9
$
+]
N:
754
3$66
581
-2*
$872
):'
5(9
352*
5(0