Rockwell Automation RECOMM-CNET ControlNet Communications Module - Manual (Page 108)

B-2 ControlNet Communications Module
Port to which the module is connected. This will usually be port 5.
Data rate used by the drive. This data rate is set in the drive and the
module detects it.
Configures the network if the Node Address Switches are set to
“00.” Updates CN Addr Act (4) after reset.
The actual network node address.
1 DPI Port
Range: 0 to 7
Default: 5
Type: Read Only
Reset Required: N/A
2 DPI Data Rate
Range: 0 = 125 Kbps
1 = 500 Kbps
Default: 0 = 125 Kbps
Type: Read Only
Reset Required: N/A
3 CN Addr Cfg
Range: 1 to 99
Default: 2
Type: Read/Write
Reset Required: Yes
4 CN Addr Actual
Range: 1 to 99
Default: 2
Type: Read Only
Reset Required: N/A