Rockwell Automation RECOMM-CNET ControlNet Communications Module - Manual (Page 15)

Installing the ControlNet Module 3-1
C
HAPTER
3
Installing the
ControlNet Module
Chapter 3 provides instructions for installing the module on an
SP600 drive.
3.1 Preparing for an Installation
Before installing the ControlNet module, verify that you have all
requirement equipment. Refer to chapter 2, Getting Started, for a
list of equipment.
3.2 Commissioning the Module
To commission the module, you must set a unique node address on
the network. (Refer to the Glossary for details about node
addresses.)
Important: New settings are recognized only when power is
applied to the module or it is reset. If you change a
setting, cycle power or reset the module.
Important: To guard against device malfunction, you must wear a
grounding wrist strap when installing the ControlNet
module.
Step 1. Set the ControlNet module’s node address by rotating the
node address switches to the desired value for each digit
as shown in figure 3.1.
Important: Each node on the ControlNet network must have a
unique address.
!
ATTENTION: The ControlNet module contains ESD-
(Electrostatic Discharge) sensitive parts that can be
damaged if you do not follow ESD control
procedures. Static control precautions are required
when handling the module. Failure to observe these
precautions could result in damage to equipment.