Rockwell Automation RECOMM-CNET ControlNet Communications Module - Manual (Page 114)

B-8 ControlNet Communications Module
Sets the data that is sent to the Datalink in the drive if any of the
following is true:
• Comm Flt Action (10) is set to Send Flt Cfg and the scanner is put
into Program mode.
• Idle Flt Action (11) is set to Send Flt Cfg and communications are
disrupted.
Configures the I/O that is transferred from the network to the drive.
17
18
19
20
21
22
23
24 Flt Cfg A1
Flt Cfg A2
Flt Cfg B1
Flt Cfg B2
Flt Cfg C1
Flt Cfg C2
Flt Cfg D1
Flt Cfg D2
Range: 0 to 4294967295
Default: 0
Type: Read/Write
Reset Required: No
25 M-S Input
Range: See figure B.3.
Default: xxx0 0001
Type: Read/Write
Reset Required: Yes
Figure B.3 – M-S Input (25)
0 0 0 1 0 x x x
0 1 2 3 4 5 6 7
1 = I/O Enabled
0 = I/O Disabled
x =Not Used
Cmd/Ref Datalink A Datalink B Datalink C Datalink D Not Used Not Used Not Used