Rockwell Automation RECOMM-CNET ControlNet Communications Module - Manual (Page 112)

B-6 ControlNet Communications Module
Configures the I/O that is transferred through the module.
I/O that the module is actively transmitting. The value of this
parameter will usually be equal to the value of DPI I/O Cfg (13).
13 DPI I/O Cfg
Range: See figure B.1.
Default: xxx0 0001
Type: Read/Write
Reset Required: Yes
Figure B.1 – DPI I/O Config (13)
0 0 0 1 0 x x x
0 1 2 3 4 5 6 7
1 = I/O Enabled
0 = I/O Disabled
x =Not Used
Cmd/Ref Datalink A Datalink B Datalink C Datalink D Not Used Not Used Not Used
14 DPI I/O Active
Range: See figure B.2.
Default: xxx0 0001
Type: Read Only
Reset Required: N/A
Figure B.2 – DPI I/O Active (14)
0 0 0 1 0 x x x
0 1 2 3 4 5 6 7
1 = I/O Enabled
0 = I/O Disabled
x =Not Used
Cmd/Ref Datalink A Datalink B Datalink C Datalink D Not Used Not Used Not Used