Rockwell Automation RECOMM-CNET ControlNet Communications Module - Manual (Page 19)

Installing the ControlNet Module 3-5
3.4 Connecting the Module to the
Network
Step 1. Remove power from the drive.
Step 2. Use static control precautions.
Step 3. Route the ControlNet cable through the bottom of the
SP600 drive. (See figure 3.3.)
Step 4. Connect the ControlNet cable to the module.
A 1786-TPS (straight tap) is recommended.
See figure 3.4 for typical ControlNet network wiring.
!
ATTENTION: The SP600 drive may contain high
voltages that can cause injury or death. Remove
power from the drive, and then verify power has
been discharged before installing or removing a
module. Failure to observe this precaution could
result in severe bodily injury or loss of life.
Figure 3.4 – Typical ControlNet Network Wiring
Scanner SP600 Drive SP600 Drive