Rockwell Automation RECOMM-CNET ControlNet Communications Module - Manual (Page 111)

ControlNet Module Parameters B-5
Sets the action that the module takes if the module detects that the
PLC is set to program mode. This setting is effective only if the I/O
that controls the drive is transmitted through the module.
Indicates either the Node Address Switches or CN Addr Cfg (03) in
the module are controlling the node address.
11 Idle Flt Action
Range: 0 = Fault
1 = Stop
2 = Zero Data
3 = Hold Last
4 = Send Flt Cfg
Default: 0 = Fault
Type: Read/Write
Reset Required: No
!
ATTENTION: Idle Flt Action (11) lets you determine
the action of the module and connected Host product
if the controller is idle (e.g., in program mode). This
parameter can be used to fault the Host product
(default) or to perform another function such as allow
the Host to continue to run. Ensure that the setting
of this parameter does not create a hazard of injury
or equipment damage. Failure to observe this
precaution could result in bodily injury or damage to
equipment.
12 CN Active Cfg
Range: 0 = Switches
1 = EEPROM
Default: 0 = Switches
Type: Read Only
Reset Required: N/A