Rockwell Automation RECOMM-CNET ControlNet Communications Module - Manual (Page 2)

©2001 Rockwell Automation. All rights reserved.
The information in this manual is subject to change without notice.
Throughout this manual, the following notes are used to alert you to safety
considerations:
Important: Identifies information that is critical for successful application and
understanding of the product.
!
ATTENTION: Identifies information about practices or
circumstances that can lead to personal injury or death, property
damage, or economic loss.
This product has been self-tested by the manufacturer and found to comply with
ControlNet International Conformance Test Software Version 12.
Windows, Windows NT, and Microsoft are trademarks of Microsoft Corporation.
ControlNet is a trademark of ControlNet International, Ltd.
Reliance, SP600, VS Utilities, DPI, RSLogix, ControlLogix, and SLC are
trademarks of Rockwell Automation.
!
ATTENTION: The drive may contain high voltages that can cause
injury or death. Remove all power from the drive, and then verify
power has been removed before installing or removing a
ControlNet module. Failure to observe these precautions could
result in severe bodily injury or loss of life.
ATTENTION: Only qualified electrical personnel familiar with
drive and power products and the associated machinery should
plan or implement the installation, start up, configuration, and
subsequent maintenance of the product using a ControlNet
module. Read and understand this manual in its entirety before
proceeding. Failure to observe these precautions could result
bodily injury and/or damage to equipment.
ATTENTION: DPI host products must not be directly connected
together via RECBL-xxx cables. Unpredictable behavior due to
timing and other internal procedures can result if two or more
devices are connected in this manner. Failure to observe this
precaution could result bodily injury and/or damage to equipment.
ATTENTION: If the ControlNet module is transmitting control
I/O to the drive, the drive may fault when you reset the module.
Determine how your drive will respond before resetting an module.
Failure to observe this precaution could result bodily injury
and/or damage to equipment.
ATTENTION: Comm Flt Action (10) and Idle Flt Action (11) let
you determine the action of the module and connected drive if
communications are disrupted. By default, these parameters fault
the drive. You can set these parameters so that the drive continues
to run. Precautions should be taken to ensure that the settings of
these parameters do not create a hazard of injury or equipment
damage. Failure to observe this precaution could result bodily
injury and/or damage to equipment.
ATTENTION: When a system is configured for the first time, there
may be unintended or incorrect machine motion. Disconnect the
motor from the machine or process during initial system testing.
Failure to observe this precaution could result bodily injury
and/or damage to equipment.
Trademarks not belonging to Rockwell Automation are
property of their respective companies.