Rockwell Automation RECOMM-CNET ControlNet Communications Module - Manual (Page 20)

3-6 ControlNet Communications Module
3.5 Applying Power
Step 1. Close the door or reinstall the cover on the drive. The
status indicators can be viewed on the front of the drive
after power has been applied.
Step 2. Apply power to the drive. The module receives its power
from the connected drive. When you apply power to the
product for the first time, the status indicators should be
green or off after an initialization. If the status indicators
are red, refer to chapter 8.
Step 3. Apply power to the master device and other devices on
the network.
!
ATTENTION: Unpredictable operation may occur
if parameter settings and switch settings are not
compatible with your application. Verify that
settings are compatible with your application
before applying power to the drive. Failure to
observe these precations could result in severe
bodily injury of loss of life.