Metrohm 756 KF Coulometer - Manual (Page 121)

6.1 Coulometer setup
756/831 KF Coulometer, Instructions of Use 113
6.1.2 Insert paper into built-in thermal printer (only at 756)
Insert the paper with the Coulometer switched on.
1. Remove old paper strips with the key <PAPER>. If the key <PAPER> does not trig-
ger a paper feed, make the following setting: <CONFIG>,
>peripheral units
man.reports to COM:int
.
2. Open cover, take out the spindle and remove the cardboard part of the old paper roll.
3. Cut a straight edge on the new paper roll. Insert this under the transport roller and
press the key <PAPER> on the Coulometer. Keep the key pressed down until suffi-
cient of the paper strip projects.
4. Insert the metal spindle through the new roll of paper.
5. Place the metal spindle in the notches at the side of the paper compartment in the
Coulometer and close the cover.
Notes
• Always operate the key <PAPER> to obtain a paper feed. Never pull the paper with
your hands as this could damage the printer.
• Thermal paper has a limited shelf life: Protect it from light! Do not store it in plastic
folders (plasticizers make the printing illegible)!
• Never operate the printer without paper!
• Use only original 6.2237.020 thermal paper! The printer head could otherwise be dam-
aged.
• If the printer no longer prints out correctly it is possible that the printer head is dirty. It
can be cleaned by inserting a sufficiently long strip of printer paper the wrong way
round in the printer and "printing" a few reports on it.