Metrohm 756 KF Coulometer - Manual (Page 76)

4.2 Remote control commands
756/831 KF Coulometer, Instructions for Use 68
&Info
Object Description Input range Reference
& Root
:
├ Info Current data
: ├ .Report Transmission of formatted reports $G 4.2.2.63.
│ ├ .Select Report type result, water crv,rate crv,
│ meas crv, comb, mplist,
│ param, calc, C-fmla, def,
│ statistics, smpl data, silo,
│ scalc full, scalc srt, config,
│ user method, all, ff ditto
│
├ .Checksums Checksums $G 4.2.2.64.
│ ├ .ActualMethod Checksum of current method read only ditto
│
├ .DetermData Determination data $G 4.2.2.65.
│ ├ .Write Read/write for several nods ON, OFF
│
├ .TitrResults Titration results
│ ├ .RS Calculated results
│ │ ├ .1 1 st result
│ │ │ ├ .Value Value read only 4.2.2.66.
│ │ ├ up to 9 results
│ ├ .EP Endpoint
│ │ ├ .V Value read only ditto
│ │ ├ .Meas Measured value read only
│ ├ .Var Variables C4X
│ │ ├ .C40 Start measured value read only/read+write ditto
│ │ ├ .C41 Mass of water read only/read+write
│ │ ├ .C42 Titration time read only/read+write
│ │ ├ .C43 Drift at titration start read only/read+write
│ │ ├ .C44 Titration temperature read only/read+write
│ │ ├ .C45 Total charge (mA·s) read only/read+write
│
├ .StatisticsVal Statistics values
│ ├ .ActN Number of results in chart read only 4.2.2.67.
│ ├ .1 1 st mean
│ │ ├ .Mean Mean read only ditto
│ │ ├ .Std Absolute standard deviation read only ditto
│ │ ├ .RelStd Relative standard deviation read only ditto
│ ├ up to 9 mean values
│
├ .SiloCalc Values of silo calculations
│ ├ .C24 Values of variable C24
│ │ ├ .Name Name read only 4.2.2.68.
│ │ ├ .Value Value read only ditto
│ │ ├ .Unit Unit read only ditto
│ ├ .C25 as for C24
│ ├ .C26 Values of variable C26
│ │ ├ .ActN Number of single values read only ditto
│ │ ├ .Mean Mean value read only ditto
│ │ ├ .Std Absolute standard deviation read only ditto
│ │ ├ .RelStd Relative standard deviation read only ditto
│ ├ .C27 as for C26