Metrohm 756 KF Coulometer - Manual (Page 48)

3.10 Data output
756/831 KF Coulometer, Instructions for Use 40
3.10 Data output
3.10.1 Reports for the output at the end of a determination
With <DEF>, the report sequence at the end of the
determination is defined.
The entries are specific to the method and are stored in
the method memory.
Report:
Definition of report blocks to be printed automatically at
the end of the determination.
The display texts of the Coulometer are shown to the
left. The values are the default values. Inquiries which
also appear in the standard operation mode are high-
lighted in gray.
>report
Only at 756:
internal:result;
At both 756 and 831:
COM1:Result;
COM2:Result;
Report sequence
Report sequence for the internal printer (result, water
crv, rate crv, meas crv, comb, mplist, param, calc, scalc
full, scalc srt, ff)
Select a block with keys < ← > and < → >. If you
require more than one report block, set a "
;
" as a
separator between the blocks.
Identical for COM1 and COM2.
Meaning of the report blocks:
result
Result report with raw results, calculations and statistics.
water crv Curve "mass water in ug" vs. time.
rate crv Curve "rate in ug/min" vs. time.
meas crv Curve measured voltage vs. time.
comb Combined curve: mass of water and rate vs. time.
mplist Measuring point list.
param Parameter report.
calc Report with formulas and operands.
scalc full Full report of silo calculations.
scalc srt Short report of silo calculations.
ff Form feed on printer.
Original reports which are put out automatically at the end of the titration can be printed
with recalculated values at any time. Key sequence:
<PRINT><REPORTS><ENTER>.
The target of these reports is as defined in the method.
def
>formula
>silo calculations
>common variables
>report
>mean
DEF
(
2