Dell POWEREDGE M1000E - Manual (Page 1023)

C-13
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix C Cisco Catalyst Blade Switch 3130 and 3032 for Dell Show Platform Commands
show platform ip unicast
show platform ip unicast
Use the show platform ip unicast privileged EXEC command to display platform-dependent IP unicast
routing information.
show platform ip unicast {adjacency | cef-idb | counts | dhcp | failed {adjacency | arp [A.B.C.D]
| route} | loadbalance | mpaths | proxy | route | rpf {A.B.C.D {A.B.C.D} | stats interface-id}
standby | statistics | table | trace} [ | {begin | exclude | include} expression]
Syntax Description
Note Though visible in the command-line help strings, the proxy and table keywords are not supported.
adjacency Display the platform adjacency database.
cef-idb Display platform information corresponding to Cisco Express Forwarding
(CEF) interface descriptor block.
counts Display the current counts for the Layer 3 unicast databases.
dhcp Display the DHCP system dynamic addresses.
failed {adjacency |
arp [A.B.C.D] | route} Display the hardware resource failures. The keywords have these meanings:
• adjacency—Display the adjacency entries that failed to be programmed
in hardware.
• arp—Display the Address Resolution Protocol (ARP) deletions because
of failure and because of retries.
• A.B.C.D—(Optional) Prefix of the ARP entries to display.
• route—Display the route entries that failed to be programmed in
hardware.
loadbalance Display the platform load-balance database.
mpaths Display the Layer 3 unicast routing multipath adjacency database.
proxy Display the platform proxy ARP database.
route Display the platform route database.
rpf {A.B.C.D
{A.B.C.D} | stats
interface-id} Display the unicast reverse path forwarding (unicast RPF) platform
information. The keywords have these meanings:
• A.B.C.D {A.B.C.D}—Prefix and prefix mask of the RPF entries to
display.
stats—Display the unicast RPF statistics for the specified interface.
standby Display the platform standby information.
statistics Display the Layer 3 unicast routing accumulated statistics.
table Display the platform IP version 4 (IPv4) information.
trace Display the platform event trace logs.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.