Dell POWEREDGE M1000E - Manual (Page 964)

B-48
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug platform ipc
debug platform ipc
Use the debug platform ipc privileged EXEC command to enable debugging of the platform-dependent
Interprocess Communication (IPC) Protocol. Use the no form of this command to disable debugging.
debug platform ipc {all | init | receive | send | trace}
no debug platform {all | init | receive | send | trace}
Note This command is supported only on stacking-capable switches.
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform ipc command is the same as the no debug platform ipc.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
all Display all platform IPC debug messages.
Note Using this command can degrade the performance of the switch.
init Display debug messages related to IPC initialization.
receive Display IPC traces each time an IPC packet is received by the switch.
send Display IPC traces each time an IPC packet is sent by the switch.
trace Display IPC trace debug messages, tracing the code path as the IPC functions are
executed.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.