Dell POWEREDGE M1000E - Manual (Page 817)

2-787
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-03
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
switchport port-security
switchport port-security
Use the switchport port-security interface configuration command without keywords on the switch
stack or on a standalone switch to enable port security on the uplink interface. Use the keywords to
configure secure MAC addresses, sticky MAC address learning, a maximum number of secure MAC
addresses, or the violation mode. Use the no form of this command to disable port security or to set the
parameters to their default states.
switchport port-security [mac-address mac-address [vlan {vlan-id | {access | voice}}] |
mac-address sticky [mac-address | vlan {vlan-id | {access | voice}}]] [maximum value [vlan
{vlan-list | {access | voice}}]]
no switchport port-security [mac-address mac-address [vlan {vlan-id | {access | voice}}] |
mac-address sticky [mac-address | vlan {vlan-id | {access | voice}}]] [maximum value [vlan
{vlan-list | {access | voice}}]]
switchport port-security [aging] [violation {protect | restrict | shutdown| shutdown vlan}]
no switchport port-security [aging] [violation {protect | restrict | shutdown | shutdown vlan}]
Syntax Description aging (Optional) See the switchport port-security aging command.
mac-address mac-address (Optional) Specify a secure MAC address for the interface by entering
a 48-bit MAC address. You can add additional secure MAC addresses
up to the maximum value configured.
vlan vlan-id (Optional) On a trunk port only, specify the VLAN ID and the MAC
address. If no VLAN ID is specified, the native VLAN is used.
vlan access (Optional) On an access port only, specify the VLAN as an access
VLAN.
vlan voice (Optional) On an access port only, specify the VLAN as a voice VLAN.
Note The voice keyword is supported only if voice VLAN is
configured on a port and if that port is not the access VLAN.
mac-address sticky
[mac-address] (Optional) Enable the interface for sticky learning by entering only the
mac-address sticky keywords. When sticky learning is enabled, the
interface adds all secure MAC addresses that are dynamically learned to
the running configuration and converts these addresses to sticky secure
MAC addresses.
(Optional) Enter a mac-address to specify a sticky secure MAC address.
maximum value (Optional) Set the maximum number of secure MAC addresses for the
interface.The maximum number of secure MAC addresses that you can
configure on a switch or switch stack is set by the maximum number of
available MAC addresses allowed in the system. This number is
determined by the active Switch Database Management (SDM)
template. See the
sdm prefer command. This number represents the
total of available MAC addresses, including those used for other
Layer 2 functions and any other secure MAC addresses configured on
interfaces.
The default setting is 1.