Dell POWEREDGE M1000E - Manual (Page 935)

B-19
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug mac-notification
debug mac-notification
Use the debug mac-notification privileged EXEC command to enable debugging of MAC notification
events. Use the no form of this command to disable debugging.
debug mac-notification
no debug mac-notification
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug mac-notification command is the same as the no debug mac-notification command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show mac
address-table
notification Displays the MAC address notification information for all interfaces or the
specified interface.