Dell POWEREDGE M1000E - Manual (Page 349)

2-319
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
match (access-map configuration)
match (access-map configuration)
Use the match access-map configuration command on the switch stack or on a standalone switch to set
the VLAN map to match packets against one or more access lists. Use the no form of this command to
remove the match parameters.
match {ip address {name | number} [name | number] [name | number]...} | {mac address {name}
[name] [name]...}
no match {ip address {name | number} [name | number] [name | number]...} | {mac address
{name} [name] [name]...}
Syntax Description
Defaults The default action is to have no match parameters applied to a VLAN map.
Command Modes Access-map configuration
Command History
Usage Guidelines You enter access-map configuration mode by using the vlan access-map global configuration command.
You must enter one access list name or number; others are optional. You can match packets against one
or more access lists. Matching any of the lists counts as a match of the entry.
In access-map configuration mode, use the match command to define the match conditions for a VLAN
map applied to a VLAN. Use the action command to set the action that occurs when the packet matches
the conditions.
Packets are matched only against access lists of the same protocol type; IP packets are matched against
IP access lists, and all other packets are matched against MAC access lists.
Both IP and MAC addresses can be specified for the same map entry.
ip address Set the access map to match packets against an IP address access list.
mac address Set the access map to match packets against a MAC address access list.
name Name of the access list to match packets against.
number Number of the access list to match packets against. This option is not valid for MAC
access lists.
Release Modification
12.2(40)EX1 This command was introduced.