Dell POWEREDGE M1000E - Manual (Page 445)

2-415
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
reload
reload
Use the reload privileged EXEC command to reload the stack member and to put a configuration change
into effect.
reload [LINE | at | cancel | in | slot stack-member-number | standby-cpu]
Note This command is supported only on stacking-capable switches.
Syntax Description
Defaults Immediately reloads the stack member and puts a configuration change into effect.
Command Modes Privilege EXEC
Command History
Usage Guidelines If there is more than one switch in the switch stack, and you enter the reload slot stack-member-number
command, you are not prompted to save the configuration.
Examples This example shows how to reload the switch stack:
Switch(config)# reload
System configuration has been modified. Save? [yes/no]: y
Proceed to reload the whole Stack? [confirm] y
This example shows how to reload a specific stack member:
Switch(config)# reload slot 6
Proceed with reload? [confirm] y
This example shows how to reload a single-switch switch stack (there is only one member switch):
Switch(config)# reload slot 3
System configuration has been modified. Save? [yes/no]: y
Proceed to reload the whole Stack? [confirm] y
LINE Specify the reason for the reload.
at Specify the time in hh:mm for the reload to occur.
cancel Cancel the pending reload.
in Specify a time interval in mmm or hhh:mm for reloads to occur.
slot stack-member-number Save the changes on the specified stack member and restart it.
standby-cpu Reload the standby route processor (RP).
Release Modification
12.2(40)EX1 This command was introduced.