Dell POWEREDGE M1000E - Manual (Page 79)

2-49
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
boot auto-copy-sw
boot auto-copy-sw
Use the boot auto-copy-sw global configuration command from the stack master to enable the automatic
upgrade (auto-upgrade) process. It automatically upgrades a switch in version-mismatch (VM) mode by
copying the running software image on any stack member or by copying a tar file image in switch stack
flash memory. Use the no form of this command to disable the auto-upgrade process.
boot auto-copy-sw
no boot auto-copy-sw
Note This command is supported only on stacking-capable switches.
Syntax Description This command has no arguments or keywords.
Defaults Enabled.
Command Modes Global configuration
Command History
Usage Guidelines A switch in VM mode is a switch that has a different minor version number than the version on the switch
stack. A switch in VM mode cannot join the switch stack as a fully functioning member. If the switch
stack has an image that can be copied to a switch in VM mode, the auto-upgrade process automatically
copies the image from a stack member to the switch in VM mode. The switch then exits VM mode,
reboots, and joins the switch stack as a fully functioning member.
The auto-upgrade process affects only switches in VM mode. It does not affect existing stack members.
Release Modification
12.2(40)EX1 This command was introduced.