Dell POWEREDGE M1000E - Manual (Page 954)

B-38
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug platform fallback-bridging
debug platform fallback-bridging
Use the debug platform fallback-bridging privileged EXEC command to enable debugging of the
platform-dependent fallback bridging manager. Use the no form of this command to disable debugging.
debug platform fallback-bridging [error | retry | rpc {events | messages}]
no debug platform fallback-bridging [error | retry | rpc {events | messages}]
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines If you do not specify a keyword, all fallback bridging manager debug messages appear.
The undebug platform fallback-bridging command is the same as the no debug platform
fallback-bridging command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
error (Optional) Display fallback bridging manager error condition messages.
retry (Optional) Display fallback bridging manager retry messages.
rpc {events | messages} (Optional) Display fallback bridging debugging information. The
keywords have these meanings:
• events—Display remote procedure call (RPC) events.
• messages—Display RPC messages.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.