Dell POWEREDGE M1000E - Manual (Page 721)

2-691
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-03
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
small-frame violation rate
small-frame violation rate
Use the small-frame violation rate pps interface configuration command on the switch stack or on a
standalone switch to configure the rate (threshold) for an interface to be error disabled when it receives
VLAN-tagged packets that are small frames (67 bytes or less) at the specified rate. Use the no form of
this command to return to the default setting.
small-frame violation rate pps
no small-frame violation rate pps
Syntax Description
Defaults This feature is disabled.
Command Modes Interface configuration
Command History
Usage Guidelines This command enables the rate (threshold) for a port to be error disabled when it receives small frames.
Small frames are considered packets that are 67 frames or less.
Use the errdisable detect cause small-frame global configuration command to globally enable the
small-frames threshold for each port.
You can configure the port to be automatically re-enabled by using the errdisable recovery cause
small-frame global configuration command. You configure the recovery time by using the errdisable
recovery interval interval global configuration command.
Examples This example shows how to enable the small-frame arrival rate feature so that the port is error disabled
if incoming small frames arrived at 10,000 pps.
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# small-frame violation rate 10000
You can verify your setting by entering the privileged EXEC command.
pps Specify the threshold at which an interface receiving small frames will be
error disabled. The range is 1 to 10,000 packets per second (pps).
Release Modification
12.2(46)SE This command was introduced.