Dell POWEREDGE M1000E - Manual (Page 84)

2-54
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
boot enable-break
boot enable-break
Use the boot enable-break global configuration command on a standalone switch to enable interrupting
the automatic boot process. Use the no form of this command to return to the default setting.
boot enable-break
no boot enable-break
Syntax Description This command has no arguments or keywords.
Defaults Disabled. The automatic boot process cannot be interrupted by pressing the Break key on the console.
Command Modes Global configuration
Command History
Usage Guidelines This command works properly only from a standalone switch in a stack.
When you enter this command, you can interrupt the automatic boot process by pressing the Break key
on the console after the flash file system is initialized.
Note Despite the setting of this command, you can interrupt the automatic boot process at any time by pressing
the MODE button on the switch front panel.
This command changes the setting of the ENABLE_BREAK environment variable. For more
information, see
Appendix A, “Cisco Catalyst Blade Switch 3130 and 3032 for Dell Boot Loader
Commands.”
Related Commands
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show boot Displays the settings of the boot environment variables.