Dell POWEREDGE M1000E - Manual (Page 818)

2-788
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-03
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
switchport port-security
Defaults The default is to disable port security.
When port security is enabled and no keywords are entered, the default maximum number of secure
MAC addresses is 1.
The default violation mode is shutdown.
Sticky learning is disabled.
Command Modes Interface configuration
vlan [vlan-list] (Optional) For trunk ports, you can set the maximum number of secure
MAC addresses on a VLAN. If the vlan keyword is not entered, the
default value is used.
• vlan—set a per-VLAN maximum value.
• vlan vlan-list—set a per-VLAN maximum value on a range of
VLANs separated by a hyphen or a series of VLANs separated by
commas. For nonspecified VLANs, the per-VLAN maximum value
is used.
violation (Optional) Set the security violation mode or the action to be taken if
port security is violated. The default is shutdown.
protect Set the security violation protect mode. In this mode, when the number
of port secure MAC addresses reaches the maximum limit allowed on
the port, packets with unknown source addresses are dropped until you
remove a sufficient number of secure MAC addresses to drop below the
maximum value or increase the number of maximum allowable
addresses. You are not notified that a security violation has occurred.
Note We do not recommend configuring the protect mode on a trunk
port. The protect mode disables learning when any VLAN
reaches its maximum limit, even if the port has not reached its
maximum limit.
restrict Set the security violation restrict mode. In this mode, when the number
of secure MAC addresses reaches the limit allowed on the port, packets
with unknown source addresses are dropped until you remove a
sufficient number of secure MAC addresses or increase the number of
maximum allowable addresses. An SNMP trap is sent, a syslog message
is logged, and the violation counter increments.
shutdown Set the security violation shutdown mode. In this mode, the interface is
error-disabled when a violation occurs and the port LED turns off. An
SNMP trap is sent, a syslog message is logged, and the violation counter
increments. When a secure port is in the error-disabled state, you can
bring it out of this state by entering the errdisable recovery cause
psecure-violation global configuration command, or you can manually
re-enable it by entering the shutdown and no shut down interface
configuration commands.
shutdown vlan Set the security violation mode to per-VLAN shutdown. In this mode,
only the VLAN on which the violation occurred is error-disabled.