Dell POWEREDGE M1000E - Manual (Page 401)

2-371
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
mvr (interface configuration)
Receiver ports cannot be trunk ports. Receiver ports on a switch can be in different VLANs, but should
not belong to the multicast VLAN.
A port that is not taking part in MVR should not be configured as an MVR receiver port or a source port.
A non-MVR port is a normal switch port, able to send and receive multicast data with normal switch
behavior.
When Immediate Leave is enabled, a receiver port leaves a multicast group more quickly. Without
Immediate Leave, when the switch receives an IGMP leave message from a group on a receiver port, it
sends out an IGMP MAC-based query on that port and waits for IGMP group membership reports. If no
reports are received in a configured time period, the receiver port is removed from multicast group
membership. With Immediate Leave, an IGMP MAC-based query is not sent from the receiver port on
which the IGMP leave was received. As soon as the leave message is received, the receiver port is
removed from multicast group membership, which speeds up leave latency.
The Immediate Leave feature should be enabled only on receiver ports to which a single receiver device
is connected.
The mvr vlan group command statically configures ports to receive multicast traffic sent to the IP
multicast address. A port statically configured as a member of group remains a member of the group until
statically removed. In compatible mode, this command applies only to receiver ports; in dynamic mode,
it can also apply to source ports. Receiver ports can also dynamically join multicast groups by using
IGMP join messages.
When operating in compatible mode, MVR does not support IGMP dynamic joins on MVR source ports.
An MVR port cannot be a private-VLAN port.
Examples This example shows how to configure a port as an MVR receiver port:
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# mvr type receiver
Use the show mvr interface privileged EXEC command to display configured receiver ports and source
ports.
This example shows how to enable Immediate Leave on a port:
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# mvr immediate
This example shows how to add a port on VLAN 1 as a static member of IP multicast group 228.1.23.4:
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# mvr vlan1 group 230.1.23.4
You can verify your settings by entering the show mvr members privileged EXEC command.
Related Commands Command Description
mvr (global configuration) Enables and configures multicast VLAN registration on the switch.
show mvr Displays MVR global parameters or port parameters.
show mvr interface Displays the configured MVR interfaces or displays the multicast
groups to which a receiver port belongs. Also displays all MVR
groups of which the interface is a member.
show mvr members Displays all receiver ports that are members of an MVR multicast
group.