Dell POWEREDGE M1000E - Manual (Page 360)

2-330
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Chapter 2 Cisco Catalyst Blade Switch 3130 and 3032 for Dell Cisco IOS Commands
mls qos cos
mls qos cos
Use the mls qos cos interface configuration command on the switch stack or on a standalone switch to
define the default class of service (CoS) value of a port or to assign the default CoS to all incoming
packets on the port. Use the no form of this command to return to the default setting.
mls qos cos {default-cos | override}
no mls qos cos {default-cos | override}
Syntax Description
Defaults The default CoS value for a port is 0.
CoS override is disabled.
Command Modes Interface configuration
Command History
Usage Guidelines You can use the default value to assign a CoS and Differentiated Services Code Point (DSCP) value to
all incoming packets that are untagged (if the incoming packet does not have a CoS value). You also can
assign a default CoS and DSCP value to all incoming packets by using the override keyword.
Use the override keyword when all incoming packets on certain ports deserve higher or lower priority
than packets entering from other ports. Even if a port is previously set to trust DSCP, CoS, or IP
precedence, this command overrides the previously configured trust state, and all the incoming CoS
values are assigned the default CoS value configured with the mls qos cos command. If an incoming
packet is tagged, the CoS value of the packet is modified with the default CoS of the port at the
ingress port.
Examples This example shows how to configure the default port CoS to 4 on a port:
Switch(config)# interface gigabitethernet2/0/1
Switch(config-if)# mls qos trust cos
Switch(config-if)# mls qos cos 4
default-cos Assign a default CoS value to a port. If packets are untagged, the default CoS value
becomes the packet CoS value. The CoS range is 0 to 7.
override Override the CoS of the incoming packets, and apply the default CoS value on the
port to all incoming packets.
Release Modification
12.2(40)EX1 This command was introduced.