Dell POWEREDGE M1000E - Manual (Page 528)

2-498
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-03
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
show env
Examples This is an example of output from the show env all command on a standalone switch:
Switch> show env all
This is an example of output from the show env stack command:
Switch> show env stack
SWITCH: 1
FAN is OK
TEMPERATURE is OK
Temperature Value: 33 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 65 Degree Celsius
Red Threshold : 75 Degree Celsius
POWER is OK
RPS is AVAILABLE
<output truncated>
This example shows how to display information about stack member 3 from the master switch:
Switch> show env stack 3
SWITCH: 3
FAN is OK
TEMPERATURE is OK
Temperature Value: 33 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 65 Degree Celsius
Red Threshold : 75 Degree Celsius
POWER is OK
RPS is AVAILABLE
This example shows how to display the temperature value, state, and the threshold values on a standalone
switch.
Table 2-25 describes the temperature states in the command output.
Switch> show env temperature status
Table 2-25 States in the show env temperature status Command Output
State Description
Green The switch temperature is in the normal operating range.
Yellow The temperature is in the warning range. You should check the external temperature
around the switch.
Red The temperature is in the critical range. The switch might not run properly if the
temperature is in this range.