Dell POWEREDGE M1000E - Manual (Page 708)

2-678
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-03
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
show vlan
20 35 community Gi1/0/13, Gi1/0/1,
Gi2/0/13, Gi3/0/14, Gi3/0/1
20 55 non-operational
2000 2500 isolated Gi1/0/5, Gi1/0/10, Gi2/0/5, Gi2/0/10
This is an example of output from the show vlan private-vlan type command:
Switch> show vlan private-vlan type
Vlan Type
---- -----------------
10 primary
501 isolated
502 community
503 normal
This is an example of output from the show vlan summary command:
Switch> show vlan summary
Number of existing VLANs : 45
Number of existing VTP VLANs : 45
Number of existing extended VLANs : 0
This is an example of output from the show vlan id command.
Switch# show vlan id 2
VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
2 VLAN0200 active Gi1/0/7, Gi1/0/8
2 VLAN0200 active Gi2/0/1, Gi2/0/2
VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
2 enet 100002 1500 - - - - - 0 0
Remote SPAN VLAN
----------------
Disabled
This is an example of output from the show vlan internal usage command. It shows that VLANs 1025
and 1026 are being used as internal VLANs for Gigabit Ethernet routed ports 7 and 8 on stack member 1.
If you want to use one of these VLAN IDs, you must first shut down the routed port, which releases the
internal VLAN, and then create the extended-range VLAN. When you start up the routed port, another
internal VLAN number is assigned to it.
Switch> show vlan internal usage
VLAN Usage
---- -------------
1025 GigabitEthernet1/0/7
1026 GigabitEthernet1/0/8