Dell POWEREDGE M1000E - Manual (Page 584)

2-554
Cisco Catalyst Blade Switch 3120 for HP Command Reference
OL-12248-03
Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands
show ip verify source
show ip verify source
Use the show ip verify source user EXEC command to display the IP source guard configuration on the
switch or on a specific interface.
show ip verify source [interface interface-id] [ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show ip verify source command:
Switch> show ip verify source
Interface Filter-type Filter-mode IP-address Mac-address Vlan
--------- ----------- ----------- --------------- -------------- ---------
gi1/0/1 ip active 10.0.0.1 10
gi1/0/1 ip active deny-all 11-20
gi1/0/2 ip inactive-trust-port
gi1/0/3 ip inactive-no-snooping-vlan
gi1/0/4 ip-mac active 10.0.0.2 aaaa.bbbb.cccc 10
gi1/0/4 ip-mac active 11.0.0.1 aaaa.bbbb.cccd 11
gi1/0/4 ip-mac active deny-all deny-all 12-20
gi1/0/5 ip-mac active 10.0.0.3 permit-all 10
gi1/0/5 ip-mac active deny-all permit-all 11-20
In the previous example, this is the IP source guard configuration:
• On the Gigabit Ethernet 1/0/1 interface, DHCP snooping is enabled on VLANs 10 to 20. For
VLAN 10, IP source guard with IP address filtering is configured on the interface, and a binding
exists on the interface. For VLANs 11 to 20, the second entry shows that a default port access control
lists (ACLs) is applied on the interface for the VLANs on which IP source guard is not configured.
• The Gigabit Ethernet 1/0/2 interface is configured as trusted for DHCP snooping.
• On the Gigabit Ethernet 1/0/3 interface, DHCP snooping is not enabled on the VLANs to which the
interface belongs.
interface interface-id (Optional) Display IP source guard configuration on a specific interface.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(40)EX1 This command was introduced.