Dell POWEREDGE M1000E User Manual

Page 545

Advertising

2-515

Cisco Catalyst Blade Switch 3120 for HP Command Reference

OL-12248-03

Chapter 2 Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Commands

show interfaces

•

se the show interface switchport module number command to display the switch port
characteristics of all interfaces on that switch in the stack. If there is no switch with that module
number in the stack, there is no output.

•

se the show interface switchport module 1 to display the switch port characteristics of all
interfaces on the switch. Any other number is invalid.

Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.

Examples

This is an example of output from the show interfaces command for an interface on stack member 3:

Switch# show interfaces gigabitethernet3/0/2

GigabitEthernet3/0/2 is down, line protocol is down

Hardware is Gigabit Ethernet, address is 0009.43a7.d085 (bia 0009.43a7.d085)

MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Auto-duplex, Auto-speed

input flow-control is off, output flow-control is off

ARP type: ARPA, ARP Timeout 04:00:00 Last input never, output never, output hang never

Last clearing of "show interface" counters never

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue :0/40 (size/max)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

2 packets input, 1040 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 0 multicast, 0 pause input

0 input packets with dribble condition detected

4 packets output, 1040 bytes, 0 underruns

0 output errors, 0 collisions, 3 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier, 0 PAUSE output

0 output buffer failures, 0 output buffers swapped out

This is an example of output from the show interfaces accounting command.

Switch# show interfaces accounting

Vlan1