Dell POWEREDGE M1000E - Manual (Page 920)

B-4
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug backup
debug backup
Use the debug backup privileged EXEC command to enable debugging of the Flex Links backup
interface. Use the no form of this command to disable debugging.
debug backup {all | errors | events | vlan-load-balancing}
no debug backup {all | errors | events | vlan-load-balancing}
Syntax Description
Command Default Backup interface debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug backup command is the same as the no debug backup command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
all Display all backup interface debug messages.
errors Display backup interface error or exception debug messages.
events Display backup interface event debug messages.
vlan-load-
balancing
Display backup interface VLAN load balancing.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.