Dell POWEREDGE M1000E - Manual (Page 974)

B-58
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug platform qos-acl-tcam
debug platform qos-acl-tcam
Use the debug platform qos-acl-tcam privileged EXEC command to enable debugging of the quality
of service (QoS) and access control list (ACL) hardware memory manager software. Use the no form of
this command to disable debugging.
debug platform qos-acl-tcam {all | ctcam | errors | labels | mask | rpc | tcam}
no debug platform qos-acl-tcam {all | ctcam | errors | labels | mask | rpc | tcam}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform qos-acl-tcam command is the same as the no debug platform qos-acl-tcam
command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
all Display all QoS and ACL ternary content addressable memory (QATM) manager
debug messages.
ctcam Display Cisco TCAM (CTCAM) related-events debug messages.
errors Display QATM error-related-events debug messages.
labels Display QATM label-related-events debug messages.
mask Display QATM mask-related-events debug messages.
rpc Display QATM remote procedure call (RPC) related-events debug messages.
tcam Display QATM hardware-memory-related events debug messages.
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.