Dell POWEREDGE M1000E - Manual (Page 931)

B-15
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Command Reference
OL-13271-03
Appendix B Cisco Catalyst Blade Switch 3130 and 3032 for Dell Debug Commands
debug ip igmp max-groups
debug ip igmp max-groups
Use the debug ip igmp max-groups privileged EXEC command to enable debugging of Internet Group
Management Protocol (IGMP) maximum groups events. Use the no form of this command to disable
debugging.
debug ip igmp max-groups
no debug ip igmp max-groups
Syntax Description This command has no arguments or keywords.
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug ip igmp max-groups command is the same as the no debug ip igmp max-groups
command.
On a stacking-capable switch, when you enable debugging, it is enabled only on the stack master. To
enable debugging on a stack member, you can start a session from the stack master by using the session
switch-number privileged EXEC command. Then enter the debug command at the command-line
prompt of the stack member. You also can use the remote command stack-member-number LINE
privileged EXEC command on the stack master switch to enable debugging on a member switch without
first starting a session.
Related Commands
Release Modification
12.2(40)EX1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.