Welch Allyn Connex CS Central Station & Server - User Manual - Manual (Page 122)

116 Connex Database Restore Welch Allyn
Restart the Data Sync Service and Wait for Completion of the Initial Sync
Operation
Follow these steps only if the database is restored on the server as part of a client-server
deployment, otherwise skip to
“Restart Services, Scheduled Tasks, and Open the CS
Application.” .
In this step, the data sync service is restarted on ALL central stations. However, it is
important to note that the best course of action is to start the data sync service on a
single central station and to wait for the initial sync cycle to complete before moving on to
the next central station. While the database on the central stations is empty, restarting
data sync on all central stations simultaneously will result in unnecessary thrashing as all
try to download data all at once from the server.
Restart Services, Scheduled Tasks, and Open the CS Application.
1. Restart the services and scheduled tasks that were shutdown previously
2. Start the Connex CS Application.
Special circumstances...
In some cases over the course of use, it may be necessary to disconnect a client Central
Station from the network for an extended period of time, such as construction projects.
In cases where the Central Station will be shut down or disconnected from the network
for more than 30 day, it becomes necessary to purge to local database and start fresh.
The local database must be dropped and recreated to maintain overall health of the
system. A future update to this Administration Guide document will detail specific steps
required.