Welch Allyn Connex CS Central Station & Server - User Manual - Manual (Page 55)

Connex CS Admin Guide Location Management 49
4. Create a new Master bed list if there are no Units present.
Caution Fields in the Master bed list control which units, rooms, and beds
appear on the Central Station and associated patient monitors. In a networked
environment with more than one Central Station, the Master bed list controls
this information for all systems. Always refer to the Connex CS Customer
Project Req. Form when entering information in these fields.
Caution If the system is configured with an ADT interface to the facility’s EMR
application, location fields for Facility, Building, Floor, and Unit must match
exactly with the ADT messages. Use a dash “-” to denote a null field if the
facility’s ADT feed does not send specific data. Data mis-matches in these
location fields will result in no patients appearing in the Connex CS
application Patient List.
Create a New Unit
1. In the Units window, click in the Facility field and enter the facility name.
2. Continue for the Building, Floor, and Unit fields. An example is shown below in
“Figure 8-5: Facility, Building, Floor and Unit entry field examples” .
3. When finished, click Add. A new entry for the Unit appears in the Units window. See
“Figure 8-6: Newly created Unit example” below.
Figure 8-5: Facility, Building, Floor and Unit entry field examples
Figure 8-6: Newly created Unit example