Welch Allyn Connex CS Central Station & Server - User Manual - Manual (Page 84)

78 Localize Station settings Welch Allyn
Figure12-6: Settings > Patient rest mode control screen composite example
8. When the station is placed into Patient Rest mode by selecting On > OK, all enabled
CVSM monitors connected to the station and running in Continuous profile will enter
the rest mode.
9. “Figure 12-7: Central station patient tiles in normal state (left) and rest state (right)”
illustrates the change in appearance of a patient tile at the Central station.
Figure 12-7: Central station patient tiles in normal state (left) and rest state (right)
10. Additionally, all new CVSM’s that connect to the central station inherit the current rest
state if enabled to support that feature.
11. Refer to the Welch Allyn Connex CS Directions for Use section title “Patient rest
mode” for additional information about this feature.
Rest mode will terminate when the device connection to the central station is lost
and an alarm condition occurs. Note