Welch Allyn Connex CS Central Station & Server - User Manual - Manual (Page 27)

5
21
Connex Server Startup
Server bootup screens
If Virtual Connex server has been installed, skip ahead to Step 8 at Windows Server
startup.
If a Hardware Connex server has been installed, follow all steps below.
1. Press the power button on the right side front bezel control panel of the server to
restart.
2. During normal startup, the server displays a number of bootup screens. The screen
remains blank for about 15 - 20 seconds, after which the Embedded RAID Controller
startup screen appears. An example is shown in
“Figure 5-1: Bootup screen with
Embedded Server RAID startup” .
Figure 5-1: Bootup screen with Embedded Server RAID startup
3. The screen above remains for about 20 seconds, and is then updated with the current
state RAID information.
4. For normal operation, RAID screens present at least 2 drives present in port 0 and 1.
In the example shown in
“Figure 5-2: Embedded Server RAID with status display” on
page 22, both port 0 and 1 are populated with drives reporting is size as about 953
GB.
5. The Virtual drive is configured as Online. This is the normal state.