Welch Allyn Connex CS Central Station & Server - User Manual User Manual
Page 64
58
Location Management
Welch Allyn
7.
Click on the new covered area, 3 South in this example, and click on Mark as default
if this is the default system for the network. See
“Figure 8-15: Covered areas window
for an example.
The default covered area provides a setting for all new devices to connect to the
network for the first time, prior to being assigned to a location. There can be only
one default covered area for a network. For a stand-alone central station, where
there is only a single covered area, always mark the covered area as default.
Figure 8-15: Covered areas window example
8.
Observe the hierarchy within the Assign beds to covered area window to the right,
click on the expander arrow next to the previously configured facility name.
9.
Keep expanding all layers until the previously configured rooms and beds are
viewable.
10. Note that the hierarchy is displayed in the following order with values previously
entered in the Master bed list:
Facility > Building > Floor > Unit > Room > Bed
11. If the covered area will be on a stand-alone central station, simple click on the Facility
to select all items underneath. A check mark appears in the box next to each selected
location in the hierarchy. An example is shown in
12. If the covered area is part of a network where multiple stations will be present, select
only the unit and/or rooms and beds to be assigned only to covered area chosen.
Refer to the Connex CS Customer Project Req. Form as needed for additional
information about specific units, bed and rooms per covered area.
Note
Note