Welch Allyn Connex CS Central Station & Server - User Manual - Manual (Page 125)

Connex CS Admin Guide Configure NRS 119
2. Enter the IP address of the Connex CS Server and click Add.
a. For a stand-alone central station, enter the IP address assigned to the workstation
computer.
b. For a networked central station, enter the IP address assigned to the Connex
server.
c. Leave the Service type set to 0 to support legacy Spot LXi devices.
Refer to the Connex CS Customer Project Req. Form as needed for IP address
information.
Assign Host for DCP Network Rendezvous
1. In the Services to be resolved by DCP Network Rendezvous window, click in the
Host field.
2. Enter the IP address of the Connex CS Server and click Add.
a. For a stand-alone central station, enter the IP address assigned to the workstation
CPU.
b. For a networked central station, enter the IP address assigned to the Connex
server.
c. Leave the Ordinal set to 8 to support CVSM devices
Refer to the Connex CS Customer Project Req. Form as needed for IP address
information.
3. An example is shown in Figure 5-18 below.
Figure 18-2: Network Rendezvous Services DCP Host entry example

4. Confirm that all information listed in the Networked Rendezvous Service window is
complete, and matches the information contained in the Connex CS Customer
Project Req. Form.
5. Click Save when finished.
6. Click on the Back button in the window header. The Stations menu appears.
Note
Note