Welch Allyn Connex CS Central Station & Server - User Manual - Manual (Page 31)

Connex CS Admin Guide Connex Server Startup 25
Confirm communication with central stations
1. Ensure that all central stations have been installed and are reachable on the network.
2. Open a command tool and ping each host by it’s assigned IP address. Refer to the
Connex CS Customer Project Req. Form, Appendix B1 as needed.
3. On the server, open the Administration Tools again.
4. On the Admin tools tab, navigate to Licensing > Pool Configuration to view the
Covered Area central stations and their respective licensing allocations. An example is
shown below.
Figure 5-6: Administrator Tools licence pool configuration window
5. Confirm that all central stations installed on the network have a column present with
the Covered Area name displaying in the Per Covered Area Licenses window.
a. In the above example, there are two Covered Areas shown, 6 South and 4 South.
b. Licenses are allocated to both Covered Areas but with differing quantities.
Confirm communication with EMR
If the server is configured for interface with the facility’s EMR application, via HL7
messaging, perform these checks. Refer to the Connex CS Customer Project Req.
Form for configuration settings of HL7 messaging options for both ADT inbound and ORU
outbound workflows.