Welch Allyn Connex CS Central Station & Server - User Manual - Manual (Page 95)

Connex CS Admin Guide Managing Device assignments 89
Figure 13-2: Device Location assignment drop down menu example
11. If the CVSM will always be located to a specific room, use the location drop down
menu to select a Unit, Room and Bed location. Check the Assigned box to
designate the monitor as permanently assigned to the select bed. An example is
shown below in
“Figure 13-3: Device Location assigned to a fixed room and bed
example” .
Figure 13-3: Device Location assigned to a fixed room and bed example
12. Repeat steps 1 through 11 for each additional continuous mode device.
13. Select Save when finished to store all device assignments.
Changing device assignments
During the course of using the system, it may become necessary to move a device from
one location to another, such as another unit.
To change a device assignment:
1. On any central station, go to Settings > Advanced settings (if required) > Devices
tab.
2. Click Edit near the bottom of the window.
3. Click on the Serial Number of the CVSM to be assigned to a different location. The
Device Configuration window populates with information from the selected CVSM.
Assignment of devices can only be taken when a device is not currently in use.
4. Use the Location drop down menu to select the new desired location, typically a Unit
name. An example is shown in
“Figure 13-4: Location drop down menu with multiple
units example” on page 90.
Note